Why Your Toilet Is Not Flushing All The Way & What To Do

Why Your Toilet Is Not Flushing All The Way & What To Do

A properly functioning toilet is an essential part of any household. However, it can be frustrating when your toilet is not flushing all the way. In this post, we will explore some of the most common reasons why your toilet is not flushing all the way and what you can do about it in terms of toilet repair.

Clogged Toilet

The most frequent cause of a toilet not flushing completely is a clogged toilet. When a blockage in the pipes prevents water from flowing as it should, a toilet can become clogged. The accumulation of waste, toilet paper, or other debris may be the reason for this obstruction.

  • What to do: To clear a clogged toilet, you can try using a plunger. First, make sure that there is enough water in the bowl to cover the plunger. Then, position the plunger over the drain and push down and up rapidly. Repeat this several times until the blockage clears. If the plunger doesn’t work, you can try using a toilet auger or call a plumber.

Low Water Level in the Tank

If the water level in the tank is too low, it will not provide enough force to flush the toilet properly. This can be caused by a faulty fill valve or an improperly adjusted float.

  • What to do: To fix this issue, you can adjust the float or replace the fill valve. To adjust the float, locate the float in the tank and adjust the screw or clip to increase the water level. If the fill valve is faulty, you may need to replace it entirely.

Faulty Flapper

The flapper is a rubber valve that opens and closes to allow water to flow from the tank to the bowl during a flush. If the flapper is damaged or worn, it may not create a proper seal, which can cause the toilet to not flush all the way.

  • What to do: First, turn off the water supply to the toilet. Then, remove the old flapper and replace it with a new one. Make sure to match the new flapper with the old one to ensure a proper fit.

Blocked Vent Pipe

The vent pipe is a pipe that runs from the roof to the plumbing system to remove sewer gas and allow air to flow into the pipes. If the vent pipe is blocked, it can cause air to become trapped in the pipes, which can prevent the toilet from flushing properly.

  • What to do: You can try using a plumbing snake to clear the blockage. If this does not work, you may need to call a plumber to inspect and repair the vent pipe.

Main Sewer Line Blockage

If none of the above solutions work, the main sewer line may be blocked. This is a more serious issue that requires immediate attention from a professional plumber.

  • What to do: Call a plumber to inspect the main sewer line and clear any blockages. Attempting to fix this issue yourself can cause further damage and be hazardous to your health.

A toilet not flushing all the way can be a frustrating problem to deal with, but it is usually a simple fix. By following the steps outlined above, you can diagnose and fix the problem quickly and easily. If the issue persists, do not hesitate to call a professional plumber to prevent further damage and ensure your safety.